GP Technics Revit 1.8.0 - English

Installation
Close all Revit versions and open GP-Technics-Revit-1.8.0-Installeren.exe.
One detected version is selected automatically; otherwise choose the versions
you need. Click Install or Update. The install button disappears when the
selected installation is current. Administrator rights are not required. Open
a project and choose Add-Ins > GP Technics > Select coil. If Revit shows a
publisher prompt, check the origin of GP Technics Duct Selector and choose
Load Once.

Place a new coil
1. Choose New coil. Select the intended duct and click Read duct. Check its
   source, connection size and local design airflow. Enter the design airflow
   yourself if Revit does not provide a usable value.
2. Complete Coil, Conditions, Limits and Reference & fouling. Prefer Outlet air
   (°C) as the selection goal. Target value displays its unit. Hover over ? for help.
3. Click Calculate and review the selected product and operating conditions.
4. Choose Automatic, In duct, At open duct end or Free placement. Click the
   placement button. The actual model outline follows the duct: green indicates
   a clear matching position; red requires a correction. Click to confirm.
   Escape cancels without a new coil or duct cut.
5. Use Place another coil to continue. Valid inputs and results are retained.
   Changed sizes or conditions require recalculation. Adding another coil does
   not update an earlier unit.

Placement methods
Automatic connects near a free end and inserts farther inside the duct. In duct
creates room and connects both air ports. At open duct end connects one free
air port. Free placement uses a separate insertion point without duct connections
or a sliding duct preview. Automatic connections require editable straight
horizontal rigid duct segments without branches, matching sizes and enough
clear space. The tool does not create reducers or elbows. For a mismatch,
both sizes are shown; choose Use duct size and recalculate.
An unambiguous system airflow direction takes precedence. Otherwise a fixed
default along the duct is used. Choose Reverse airflow direction before placement
if required. Check orientation, water side, air connections and pipe connections,
which you complete manually.

Update an existing coil
Click Read existing coil and select the intended GP unit. Check the displayed
update target, edit conditions and calculate again. Click Update coil and review
the differences. New coil leaves update mode. For several units, use Recalculate
coils on the GP Technics ribbon and review before applying.

Conditions and documents
Matching saved project conditions provide a starting point. Check the actual
inlet conditions: a downstream coil receives air after upstream components.
The tool does not automatically calculate the entire chain. Keep the datasheet
with the project. View in Mollier opens the selected operating condition.
Choose Nederlands/English at the top for the interface; datasheets have a separate
language choice. Scrolling does not change closed input fields.

Models and updates
Backup families are in Modellen/2024 for Revit 2024, 2025 and 2026, and in
Modellen/2027 for Revit 2027. The plugin uses the verified model release for
the calculation. Calculations and current documents require internet.
The plugin checks for compatible updates at startup. Close Revit before running
a new installer. Use the installer to uninstall; saved selections and settings
are retained. See the illustrated user guide for the complete instructions.

GP Technics Luchtbehandeling B.V. | https://www.gptechnics.nl/revit
